Not known Details About winchester small rifle primers

Not known Details About winchester small rifle primers

Blog Article

Highlights problem with reporting of checks... even though a guy will take constantly and $$ to do this, the take a look at results is often unusable due to insufficient rigor in either loading procedures or reporting.



I assumed It will be worthwhile to me, to essentially find out just how subbing Cheddite primers inside a load that calls for a Winchester 209. In line with Alliant Sites loading data for an AAHS hull, 28 gauge working with:

We in no way propose substituting primers, nevertheless if you decide on to employ a Cheddite primers in lieu on the Winchester you'll likely see considerably less stress and velocity as the Cheddite primer is usually a ‘cooler’ primer when compared to the Winchester.

none of them are the identical [aside from when nobel sport was making use of winchesters recipe to make primers for them]

This is my opinion as well. You have got loads of "headroom" on force for that primer substitution. Also, since you already hold the go in advance from Alliant to sub in the Gain primer with the Rem, It will likely be OK to sub inside the Cheddite primer as (I think) it truly is "cooler" in comparison to the Gain primer.

"A perfectly controlled Militia, currently being important to the safety of a cost-free State, the appropriate of the folks to maintain and bear Arms, shall not be infringed"

This does not seem to be a universal difficulty, but it was ample to move me faraway from them a number of decades winchester usa ready 9mm review in the past.

Or none of the previously mentioned? So there was a obvious modify in performance. Also the seem was decrease than my previous loads which were Fed209A. Once i shot the Feds I altered my headset trigger I believed they were being away from put through the audio staying as well loud. Nonetheless they were on just fine.

This is more what I envisioned to see for W209/C209-little distinction between powder demands for the same velocity, and nearer pressures.

This is an older thread, you may not get a response, and could be reviving an aged thread. Please look at creating a new thread.

I have used largely cheddite primers but have used a couple of Winchester primers with none challenges or adjustments on my MEC 9000 loading Remington and Winchester hulls.  

After i was looking for load data I had identified as Ballistic Goods (where by I bought the primers from). They informed me in excess of the mobile phone that I could swap inside a Cheddite primer to get a W209 If your tension was under 10k PSI.

I feel have been the primers that were not really trustworthy ! I've some NEW Ched hulls with black sealer but They are really at the least ten

Anyways, my point it that it will require a great deal of exertion to both layout an accurate check then Produce UP the data so It really is usable and might be duplicated and relied on by Other folks. These issues higher than might have impacts on trustworthiness of data, however most people hardly ever report them perfectly.